Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. Position shock assembly coil spring (1) on hooks (2) of Compressor following manufacturers instructions. Install clamp securing shock to lower
spring coil.
2. Position Compressor upper hooks (1) on upper coil spring (2) following manufacturers instructions. To ease installation, rotate shock as necessary
positioning shock in compressor so that upper spring coil ends (step in upper mount) at straight outward position from Compressor.
3. Compress coil spring until all spring tension is removed from upper mount.
4. Position Wrench (2), Special Tool 9362, on shock shaft retaining nut. Next, insert 8 mm socket though Wrench onto hex located on end of shock
shaft. While holding shock shaft from turning, remove nut from shock shaft using Wrench.
5. Remove clamp from bottom of coil spring and remove shock and lower isolator out through bottom of coil spring.
