Magnum SRT-8 V8-6.1L VIN 3 (2006)
17.
Install the new transmission oil filter.
18.
Verify that both oil cooler line connections to the transmission are correct and tight. Install the dust covers over each connections.
19.
Install the transmission oil pan using the original oil pan gasket. Tighten the retaining bolts to 8 Nm (70 in. lbs.).
20.
Proceed to Section C - Fill Tube Oil Seal Replacement.
F. Fill and Mix Transmission Oil Prior to Flush
F.
Fill And Mix The Transmission Oil Prior To Flush:
1.
Lower the vehicle.
2.
On vehicles that had the torque converter replaced, pour 7.5 liters (8 quarts) of new ATF+4 transmission oil into the transmission through the fill
tube.
3.
On vehicles that DID NOT have the torque converter replaced, pour 4.75 liters (5 quarts) of new ATF+4 transmission oil into the transmission
through the fill tube.
4.
Mix the transmission oil before flushing the transmission fluid from the transmission.
a.
Turn off the air conditioning.
b.
With the parking brake engaged and the service brake pedal applied, start the engine.
c.
Allow the engine to idle for a moment.
d.
With the brakes fully applied, place the transmission in "Reverse" and open the throttle 25% for 10 seconds. Release the throttle.
e.
Place the transmission in "Neutral" and hold the engine RPM's at 2,000 for 10 seconds.
f.
With the brakes fully applied, place the transmission in "Drive" and open the throttle 25% for 10 seconds. Release the throttle.
g.
Place the transmission in "Neutral" and hold the engine RPM's at 2,000 for 10 seconds.
h.
With the brakes fully applied, place the transmission in "Reverse" and open the throttle 25% for 10 seconds. Release the throttle.
i.
Place the transmission in the "Park" position and turn off the engine.
