Magnum SRT-8 V8-6.1L VIN 3 (2006)
22. Finish separating the upper shift housing from the lower shift housing (Figure 5).
24. Remove and discard the pink interlock lever.
25. Install the new interlock lever onto the pivot shaft.
CAUTION:
Do not apply any type of lubricant to the pivot shaft.
26. Connect the interlock lever return spring.
27. Place the upper shift housing into position and connect the electrical connector located inside the shifter assembly.
28. Snap the upper shift housing into place on the lower shift housing.
CAUTION:
The shifter must not be in the "PARK" position when assembling the shifter.
29. Place the shifter assembly back into the vehicle.
30. Install the four shifter assembly mounting nuts and tighten them to 65 in.lbs. (7 N.m).
31. Install the carpet push pin.
32. Connect the shift interlock cable to the shifter assembly.
33. Connect the shift cable to the shifter assembly pivot pin.
34. Connect the electrical connectors to the shifter assembly.
35. Snap the shifter indicator bezel (PRNDL) into place (Figure 3).
CAUTION:
Be sure to install the light for the shift indicator and route the wiring correctly.
36. Install the center console into the vehicle.
37. Loosely install all fasteners that retain the center console.
38. Tighten all of the fasteners that retain the center console securely.
42. Install the center console shifter bezel.
43. Install the shifter knob retaining ring onto the gear shifter stalk.
