Magnum SRT-8 V8-6.1L VIN 3 (2006)
8. Remove center bearing (1) mounting bolts.
9. With the aid of a helper, remove propeller shaft assembly.
INSTALLATION - REAR
CAUTION: Propeller shaft installation is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only connected
to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage may occur to the shaft, coupler,
and/or center bearing from over-angulation. This may result in driveline vibrations and/or component failure.
COUPLER/DAMPER SERVICE
1. If coupler and/or damper (V6 Models) were removed, align index marks and reinstall. Make sure protruding sleeve (2) is properly seated into
propshaft or damper counterbores.
2. Install three bolts with washers and nuts and torque to 58 Nm (43 ft. lbs.) torque.
