Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. Load the regulator into the door (3) through the large access hole on the inside of the door near the front.
2. Position the rear regulator within the door so that the door wire harness connector (1) can be reconnected to the regulator motor (2) through the
large access hole on the inside of the door.
3. Engage the screw at the bottom of the rear regulator rail (2) into the keyed hole (3) on the inside of the door near the bottom.
4. Install and tighten the screw (1) that secures the top of the rear regulator rail to the inside of the door. Tighten the screw to 10 N.m (90 in.lbs.).
5. Install and tighten the screw (4) that secures the regulator motor support bracket to the inside of the door. Tighten the screw to 10 N.m (90 in.lbs.).
6. Tighten the screw that secures the bottom of the regulator rail to the keyed hole on the inside of the door. Tighten the screw to 10 N.m (90 in.lbs.).
