Mini Ram Van L4-134 2.2L SOHC VIN C 2-BBL (1987)
FIGURE 4 - PRESSURE REGULATOR BRACKET INSTALLATION
E.
Engine Compartment Fuel Component Installation
1.
On the right side of the dash panel, mark the location of the pressure regulator bracket top attaching hole as shown in Figure 4. Center punch
and drill a 1/8" diameter hole and attach pressure regulator bracket, PN 4306972, with selftapping screw, PN 6031991. (Position the bracket
so its top surface is horizontal and tighten screw securely.) Drill 1/8" diameter holes in the center of the two lower bracket holes. Install the
remaining two screws, PN 6031991, and tighten securely.
2.
Attach the pressure regulator assembly, PN 4307380, to the bracket, PN 4306972, with two self-tapping screws, PN 6033066, and tighten
securely.
