dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C, Heater - Temperature Lever Difficult to Move|Page 2964 > < Front Hub/Bearing/ Seal - Manual Revision|Page 2954
Page 1
background image

Air Door: Customer Interest
A/C, Heater - Temperature Lever Difficult to Move

NO: 24-11-94

GROUP: Heater & A/C

DATE: Jul. 1, 1994

SUBJECT:
A/C Heater Blend Air Door Sticking

MODELS:

1989 - 1994 (AS) Town & Country/Caravan/Voyager 
1984 - 1988 (S) Caravan/Voyager

SYMPTOM/CONDITION:

Poor heater performance, or poor A/C performance, and/or temperature control lever difficult or impossible to move.

DIAGNOSIS:

Check the temperature control lever for a binding condition. If the lever is difficult or impossible to move, perform the repair procedure.

PARTS REQUIRED:

AR

4318039

Mopar Rust Penetrant

AR

4318066

Mopar White Spray Lube

REPAIR PROCEDURE:

This bulletin involves accessing the lower pivot and contact surfaces of the blend air door shaft to apply rust penetrant to free up the shaft and then apply
lubricant to prevent further corrosion.

1.

Remove the center floor console on vehicles so equipped.

2.

Remove the floor air distribution duct.

3.

On the extension which houses the blend air door shaft inside the heater-A/C housing (Refer to Illustration), drill a 3/32 in. (2.2 mm) hole
perpendicular to the side of the extension and 3/8 in. (10 mm) up from the bottom of the extension to gain access to the blend air door shaft.

A/C, Heater - Temperature Lever Difficult to Move|Page 2964 > < Front Hub/Bearing/ Seal - Manual Revision|Page 2954