Mini Ram Van L4-156 2.6L SOHC VIN G 2-bbl (1984)
service gauge unit only
4397835
4419434
Fuel pump service kit for
service pump unit only
4397833
4419435
Attached are revised pages for the vapor lock bulletins with part number changes as a result of the modification to the fuel pick-up tube and filter. Also
included is a revised page where a note has been added pertaining to high altitude vehicles.
These bulletin numbers and revised pages are as follows:
Bulletin Number
Pages to be Replaced
18-13-85 REVISION A
Pages 2, 4, 7, and 8
18-18-85 REVISION A
Pages 1, 4, and 7
18-07-86
Pages 2, 4, 7, and 8
18-08-86
Pages 1, 4, 5, and 7
Insert the revised pages in the appropriate bulletins.
REPAIR PROCEDURES
The following procedures involve the replacement of the 90~ formed hose (connecting the electric fuel pump to the gauge unit fuel tube) with a straight
hose, and replacing the straight filter with a "T" filter. In addition to reworking vehicles with the vapor lock kits installed, any vapor lock kits or service
kits for gauges and fuel pumps must also be reworked if they carry the old part numbers.
This procedure applies to converting vapor lock packages to the updated packages. This same procedure also applies to reworking service gauge/pump
units to the updated service packages. Rework kit, PN 4075490, must be used.
1.
Locate gauge/pump unit, PN 4075448 or 4075449. If removal from gas tank is necessary, follow service manual procedure.
FOR THE ENTIRE REWORK PROCEDURE USE EXTREME CAUTION NOT TO BEND THE FLOAT ARM AND HINGE ASSEMBLY.
FIGURE 1
2.
Disconnect both black and red wire terminal attachments at the fuel pump and carefully bend back from fuel hose area.
3.
Remove and discard both fuel hose clamps. Remove and discard the fuel hose containing the 90~ bend. Be sure to note the position of the fuel
pump (Figure 1).
