Mini Ram Van L4-156 2.6L SOHC VIN G 2-bbl (1984)
4.
Remove the existing hose clip on the valve cover and discard.
5.
Attach the 7" long hose on the reservoir inlet to the fuel pump outlet nipple (Figure 1) and clamp with hose clamp, PN 6500650. Torque to 10 inch
pounds.
FIGURE 2 - PRESSURE REGULATOR BRACKET INSTALLATION
6.
On the right side of the dash panel mark the location of the pressure regulator bracket top attaching hole as shown in Figure 2. Center punch and
drill a 1/8" diameter hole and attach pressure regulator bracket, PN 4306972, with self-tapping screw, PN 6031991. (Position the bracket so its top
surface is horizontal and tighten screw securely.) Drill 1/8" diameter holes in the center of the two lower bracket holes. Install the remaining two
screws, PN 6031991, and tighten securely.
7.
Attach the pressure regulator assembly, PN 4307381, to the bracket, PN 4306972, with two self-tapping screws, PN 6033066, and tighten
securely.
