Mini Ram Van L4-156 2.6L SOHC VIN G 2-bbl (1984)
15.
Drain and save coolant.
16.
If the vehicle is equipped with a fuel reservoir, it will need to be set aside by removing the thermostat housing bolt that secures the reservoir.
17.
Remove the coolant temperature sensor (2-wire) and temperature gauge sending unit (1-wire) to gain access to the thermo valve.
18.
Remove both vacuum lines from the thermo valve. Disconnect the vacuum line from the thermo valve to the EGR valve at both ends and discard.
This hose is provided on the new harness.
19.
Remove the thermo valve and replace it with the 3-port valve, PN MD097330, provided in the kit. Before installation, apply Loctite/Mopar
Sealant, PN 4318034, to the threads.
FIGURE 9
20.
Install the VSV bracket, PN MD100733, provided in the kit. The bracket is mounted using the two (2) EGR bolts (Figure 9).
