Mini Ram Van L4-156 2.6L SOHC VIN G 2-bbl (1984)
1.
Remove distributor rotor.
2.
Remove governor assembly retaining screw, Fig. 4, and governor assembly. Governor springs are not interchangeable and must be installed
in their original positions. Note position of each spring during disassembly for reference during assembly.
3.
Remove wire retaining clamp from side of distributor.
4.
Remove pickup coil and ECU igniter retaining screws, then remove pickup coil and ECU igniter as an assembly, Fig. 5.
5.
Remove vacuum chamber retaining screws, then the vacuum chamber assembly.
6.
Remove breaker assembly retaining screws, then the breaker assembly.
7.
Remove bearing retainer plate screws, then the bearing retainer plate.
8.
Mark relationship of distributor drive gear to distributor shaft, Fig. 6, then punch out distributor drive gear retaining pin and remove gear from
shaft.
9.
Remove distributor shaft and bearing assembly from housing.
10.
Remove distributor housing seal.
