Mini Ram Van L4-156 2.6L SOHC VIN G 2-bbl (1984)
Constant Velocity Joint: Service and Repair
Outer CV Joint
Fig. 23 Driveshaft components
Fig. 26 Removing outer C/V joint from shaft
DISASSEMBLY
Driveshaft assembly should be identified before starting service procedure. Refer to "Driveshaft Identification" procedure.
1. Remove boot clamps, then pull back boot to gain access to joint.
2. Clean grease from joint.
3. Place driveshaft assembly in suitable vise and support outer joint. Remove outer joint from shaft by tapping top of joint body with a soft hammer.
4. Remove circlip from shaft groove and discard.
5. On G.K.N. units, remove heavy lock ring from shaft only if shaft needs replacement.
6. On all units, if constant velocity joint is operating satisfactorily and grease does not appear contaminated, proceed to "Assembly" procedure, step
7.
7. If constant velocity joint is noisy or badly worn, replace entire unit. The repair kit will include boot, clamps, circlip and lubricant. Clean and
inspect joint outlined in the following steps.
