Monaco V6-182 3.0L SOHC (1990)
Fig. 19 Dowel Extractor Special Tool 7314
24. Use Special Tool 7314 to remove the cylinder head locating dowels Fig. 19.
25. Stuff the cylinder bores with clean lint free shop towels.
26. Install cylinder liner clamps (Tool 7315) to hold the liners in place.
27. use a gasket removal compound to s6ften the old gasket material.
CAUTION: When cleaning the cylinder head and block mating surfaces, do not use a metal scraper because the surfaces could be cut or ground.
Instead, use a wooden or plastic scraper.
Fig. 20 Oil Feed And Return Holes
28. Make sure that gasket and/or foreign material does not enter the oil feed hole or the oil return hole Fig. 20.
29. Rinse and wipe clean the cylinder block and cylinder head mating surfaces.
30. Check the liner protrusion. The liner protrusion should be between 0.05 mm and 0.12 mm (.002 in and .005 in).
