Neon L4-122 2.0L DOHC VIN Y SFI (1997)
3. Install the tie rod end into the steering knuckle. Start tie rod end to steering knuckle attaching nut onto stud of tie rod end. While holding stud of tie
rod end stationary, tighten tie rod end to steering knuckle attaching nut. Then using a crowfoot and 11/32 socket, torque the tie rod end attaching
nut to 61 Nm (45 ft. lbs.).
CAUTION: During this procedure do not allow the steering gear boot to become twisted.
4. Adjust the front Toe setting on the vehicle. Refer to Alignment.
5. Torque the tie rod jam nut to a torque of 55 Nm (40 ft. lbs.) torque.
6. Adjust the steering gear to inner tie rod boots at inner tie rod if they became twisted during Toe adjustment.