Neon L4-2.0L DOHC (1996)
2. Disconnect the electrical connector from the MAP/IAT sensor.
3. Remove sensor mounting screws.
4. Remove sensor.
INSTALLATION
1. Insert sensor into intake manifold while making sure not to damage 0-ring seals.
2. Tighten mounting screws to 2 Nm (20 in lb) torque for a plastic manifold and 3 Nm (30 in lb) for a aluminum manifold.
3. Attach electrical connector to sensor
4. Install air inlet duct wing nut and duct from intake manifold, insure that the duct does not interfer with ignition cables.
