Neon L4-2.0L SOHC (1995)
OPERATION
The camshaft position sensor attaches to the rear of the cylinder head (Fig. 5). A target magnet attaches to the rear of the camshaft and indexes to
the correct position. The target magnet has four different poles arranged in an asymmetrical pattern (Fig. 6). As the target magnet rotates, the
camshaft position sensor senses the change in polarity (Fig. 7).
The sensor output switch switches from high (5.0 volts) to low (0.5 volts) as the target magnet rotates.
-
When the north pole of the target magnet passes under the sensor, the output switches high.
-
The sensor output switches low when the south pole of the target magnet passes underneath.
Fig. 24 Square Wave Pattern In Crankshaft Degrees
Square Wave Output
The output voltage of a properly operating camshaft position sensor or crankshaft position sensor switches from high (5.0 volts) to low (less than
0.5 volts). By connecting an oscilloscope to the sensor output circuit, technicians can view the square wave pattern produced by the voltage swing
(Fig. 24).
If the camshaft position sensor and crankshaft position sensor don't produce a square wave pattern, check the 8-volt supply circuit that feeds both
sensors.
The sensor also acts as a thrust plate to control camshaft endplay.
CIRCUIT OPERATION
Circuit K7 supplies 8 volts from the Powertrain Control Module (PCM) to the camshaft position sensor. The K7 circuit connects to cavity 44 of
the PCM connector, and cavity 3 of the camshaft position sensor.
Circuit K44 from the sensor provides an input signal to the PCM. The K44 circuit connects to cavity 26 of the PCM, and cavity 1 of the camshaft
position sensor.
The PCM provides ground for the camshaft position sensor signal (circuit K44) through circuit K4. Circuit K4 connects to cavity 51 of the PCM
connector, and cavity 2 of the camshaft position sensor connector.
