Neon L4-2.0L SOHC (1995)
Throttle Body: Service and Repair
Manual Transmission
Fig. 3 Throttle Cable Attachment To Throttle Body
Fig. 4 Disconnecting Throttle Cable
REMOVAL
1. Remove throttle cable from the throttle body lever (Figs. 3 and 4).
2. Compress the retaining tabs on the cable and slide cable out of bracket (Fig. 4).
3. If equipped with speed control, remove speed control cable from throttle lever by sliding clasp out hole used for throttle cable.
INSTALLATION
1. Install throttle body on intake manifold. Tighten mounting bolts.
2. Attach cable mounting bracket and support bracket with 2 screws.
3. Install cable housing(s) retainer tabs into bracket.
4. Install throttle body cables using the following procedures.
5. If equipped with speed control, rotate the throttle lever forward to the wide open position and install speed control cable clasp (Fig. 4).
6. Rotate throttle lever to wide open position and install throttle cable clasp (Fig. 4).