Neon L4-2.0L SOHC (1995)
Fig. 4 Removing Ignition Switch
6. Depress retaining tabs and pull ignition switch from steering column.
Fig. 5 Ignition Switch Installation
INSTALLATION
1. Ensure the ignition switch is in the Run position and the actuator shaft in the lock housing is in the Run position.
2. Carefully install the ignition switch. The switch will snap over the retaining tabs. Install mounting screw.
3. Install electrical connectors to ignition switch.
4. Install upper and lower shrouds.
5. Install key cylinder (cylinder retaining tab will depress only in the Run position).
6. Connect negative cable to battery.
7. Check for proper operation of ignition switch and key-in warning switch.