Neon L4-2.0L SOHC (1995)
2.
Type the required information on the Authorized Modification Label (as illustrated), and attach near the VECI Label.
VEHICLES BUILT AFTER AUGUST 6, 1994:
NOTE:
THE MOPAR DIAGNOSTIC SYSTEM IS REQUIRED TO PERFORM THE FOLLOWING REPAIR. THE SYSTEM MUST BE OPERATING
WITH RELEASE 15 OR HIGHER INSTALLED.
This repair involves selectively erasing and reprogramming the Powertrain Control Module with new software (calibration change).
1.
Connect the MDS (Mopar Diagnostic System) and DRBIII (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 MDS DIAGNOSTICS on the DRBIII MAIN MENU Screen.
3.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
4.
Use the arrow keys and select CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select PROGRAM CONTROLLER PART on the MDS, then press NEXT MENU.
6.
Follow the steps presented on the MDS and DRBIII which will allow the DRBIII to obtain the current part number of the controller.
7.
The MDS will display the part number of the controller on the vehicle and the appropriate replacement part number, then press NEXT MENU to
begin programming.
If the controller on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the
part number of the controller on the vehicle and compare it to the part number displayed. If the controller has already been updated, proceed to
step 9.
8.
The MDS and DRBIII will prompt for any operator action needed during the remainder of the programming process.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
9.
Type the necessary information on the "Authorized Software Update Label" and attach it to the PCM and cover the label with a clear plastic
sticker.
