Neon L4-2.0L SOHC (1995)
Air Bag: Service and Repair
Passenger Side Airbag Module Replacement
Deployed Module
Fig. 7 Remove Or Install Battery Cable
WARNING: When removing a deployed module, rubber gloves, eye protection, and a long-sleeved shirt should be worn, as there may be
deposits on the surface which could irritate the skin and eyes.
WARNING: When vehicle is involved in an impact great enough to deploy the airbag modules, the steering coupler will have to be replaced.
WARNING: Replace airbag system components with Chrysler Mopar (R) specified replacement parts. Substitute parts may visually appear
interchangeable, but internal differences may result in inferior occupant protection.
DEPLOYED MODULE
The vehicle interior may contain a very small amount of sodium hydroxide powder, a by-product of airbag deployment. Since this powder can
irritate the skin, eyes, nose or throat, be sure to wear safety glasses, rubber gloves and long sleeves during cleanup.
If you find that the cleanup is irritating your skin, run cool water over the affected area. Also, if you experience nasal or throat irritation, exit the
vehicle for fresh air until the irritation ceases. If irritation continues, see a physician.
SERVICE OF DEPLOYED AIRBAG MODULE
After a PASSENGER airbag has been deployed, the passenger airbag module must be replaced because it cannot be reused. Other components are
replaced if damaged. These might include the trim bezel, top cover or the entire instrument panel.
Fig. 4 Wear Safety Glasses And Gloves
CLEAN UP
Wear safety glasses, rubber gloves, particle dust mask and protective clothing with long sleeves. Place tape over exhaust vents in air bag so that no
additional powder will escape into vehicle. Roll or fold passenger's air bag toward instrument panel surface and close cover over folded air bag.
Tape cover closed. Remove driver's air bag module from vehicle then passenger's air bag module.
