Neon L4-2.0L SOHC (1995)
Fig. 13 Groove In Back Side Of Level Sensor
INSTALLATION
1. Insert level sensor wires into bottom of opening in module.
2. Wrap wires into groove in back of level sensor.
Fig. 14 Installation Channel
3. While feeding wires into guide grooves, slide level sensor up into channel until it snaps into place
4. Install level sensor wires in connector. Push the wires up through the connector and then pull them down until they lock in place. Ensure signal and
ground wires are installed in the correct position.
5. Install locking wedge on connector.
6. Push connector up into bottom of fuel pump module electrical connector.
7. Install fuel pump module. Refer to procedure.
