Neon L4-2.0L SOHC (1995)
NOTE: The vehicle speed sensor is located in the transmission extension housing (Fig. 24).
REMOVAL
1. Disconnect electrical connector from sensor.
2. Remove the sensor mounting bolt.
3. Lift the sensor out of the transaxle extension housing. Ensure the 0-ring was removed with the sensor.
NOTE: The speed sensor gear meshes with a gear on the output shaft.
INSTALLATION
1. With 0-ring in place, install sensor and seat sensor by hand -- to ensure proper gear engagement.
2. Install mounting bolt and torque bolt to 7 Nm (60 in lb).
3. Connect electrical connector to sensor.