Neon L4-2.0L SOHC (1995)
**NOTE:
USE TABLE TO DETERMINE WHICH STEPS TO PERFORM BASED ON VEHICLE BUILD DATE AND IF TECHNICAL SERVICE
BULLETIN 02-02-97, DATED FEBRUARY 28, 1997 HAS BEEN PERFORMED.**
NOTE:
ALL FRONT KNUCKLE/BEARING/HUB REPAIR PROCEDURES FOR STEPS 1 THROUGH 5, CAN BE FOUND IN THE 1998 NEON
SERVICE MANUAL (PUBLICATION NUMBER 81-270-8025) GROUP 2 (SUSPENSION).
1.
Remove both left and right front knuckle/bearing/hub assemblies.
2.
Press the hub out of the old knuckle/bearing/hub assemblies.
3.
Press the old hubs into the new knuckle/bearing assemblies.
**4. Before the knuckle/bearing/hub assemblies are installed on the vehicle, put a small amount of grease (Wheel Bearing Lube - p/n 04318064) on the
entire face of the driveshaft that makes contact with the hub bearing assembly (Figure 1).**
5.
Install both left and right front knuckle/bearing/hub assemblies.