Neon L4-2.0L SOHC (1995)
Hub Bearing Race Removal
7. Install assembly into press, then place driver tool on end of hub and press hub out of hub bearing race.
ASSEMBLE
1. Install new bearing into bore of steering knuckle so it is square with bore, then place steering knuckle in press with receiver tool No. C-4698-2, or
equivalent, supporting steering knuckle.
2. Place driver tool No. 5052, or equivalent, on outer race of hub, then press hub bearing into steering knuckle until it is fully bottom in bearing bore
of steering knuckle.
3. Install hub bearing retaining snap ring into groove in hub bearing bore of steering knuckle. Ensure snap ring is fully seated.
Hub Bearing Installation
4. Place steering knuckle with hub bearing installed in press with receiver tool No. MB-990799, or equivalent, supporting inner race of hub bearing.
5. Place hub into hub bearing ensuring it is square with bearing.
6. Place driver tool No. 6522, or equivalent, on front face of hub, then press hub into bearing until it bottoms in hub bearing.
