Neon L4-2.0L SOHC (1995)
Adjustment is now complete and any throttle cable backlash has been automatically removed. Test the throttle pressure cable assembly for
freedom of operation by moving the transaxle throttle control lever forward (counterclockwise). Then slowly release the lever to confirm it
will return fully rearward (clockwise). No lubrication is required for the throttle cable system.
C.
Road test the vehicle to verify the flare condition is corrected.
2.
If the flare condition persists, replace the kickdown bracket on the throttle body with the appropriate bracket specified in the Parts Required
section of this bulletin. Then perform Step 1 again.
3.
If the flare condition persists, replace the transaxle valve body (P/N 4659879), use the following procedure:
A.
Record the radio station presets and disconnect the battery cables.
B.
Pull the Power Distribution Center (PDC) up and out of its holding bracket. Set the PDC aside to gain clearance.
C.
Remove the battery from the vehicle and disconnect the cruise control, if equipped.
D.
Loosen the throttle pressure cable lever and gear shift cable lever pinch bolts. Refer to Figure 2. Remove both levers from their shafts and
set aside.
E.
Raise the vehicle on an appropriate hoist.
F.
Clean the bottom of the transaxle.
G.
Remove the transaxle oil pan and properly dispose of the fluid. Be sure to remove all sealant from the mating surfaces.
H.
Remove the neutral start/back-up lamp switch. Refer to Figure 3.
I.
Remove and discard the transaxle oil filter.
