dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Front Drive Axle - Vibration in Floor/Dash|Page 6213 > < Clutch Pedal - Squeak/Creak/Chirp Noises|Page 6202
Page 1
background image

Technical Service Bulletin # 020195

Date: 950127

Front Drive Axle - Vibration in Floor/Dash

NO: 02-01-95

GROUP: Front Suspension

DATE: Jan. 27, 1995

SUBJECT: 
Vibration in Floor Pan/Dash Panel 2800 to 4200 RPM Range

MODELS:
1995 (PL) Neon

NOTE:

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH AUTOMATIC TRANSAXLES AND BUILT PRIOR TO OCT. 24, 1994 (MDH
10-24-XX).

SYMPTOM/CONDITION:

Right side driveshaft vibration coming from the engine compartment and occurring between 2800 and 4200 RPM. The vibration is most noticeable at
approximately 3200 RPM and may be felt in the floor pan and/or in the dash panel.

DIAGNOSIS:

1.

Start the vehicle and place the transmission in neutral or park. Set the parking brake.

2.

Slowly depress the accelerator pedal until the engine reaches approximately 4800 RPM. Pay particular attention for any vibration (other than
normal engine/exhaust vibrations) starting at around the 2800 RPM and most evident around 3200 RPM, then getting less noticeable and
disappearing around 4200 RPM. The vibration may be felt in the floor pan and/or in the dash.

3.

If a vibration is felt that starts and disappears at the RPM ranges listed above, perform the repair procedure. If the vibration does not conform to
these RPM ranges, follow the vibration diagnostic procedure listed in the 1995 Service Manual.

PARTS REQUIRED:

1

4670280  Driveshaft - ATX Without ABS -Rt

1

4670282  Driveshaft - ATX With ABS -Rt

1

6500336  Pin, Cotter

Service Procedure

REPAIR PROCEDURE:

This bulletin involves replacing the right side driveshaft with a revised part.

Figures 1-2

Front Drive Axle - Vibration in Floor/Dash|Page 6213 > < Clutch Pedal - Squeak/Creak/Chirp Noises|Page 6202