Neon L4-2.0L SOHC (1995)
4.
Complete the reassembly of the Transaxle following the instructions listed on Page 21-27. Use new Roll Pins supplied in the repair package when
assembling the Crossover and Selector Levers to the Transaxle. While still on the bench, make sure that all gears can be selected and the Transaxle
is functioning properly.
5.
Install the Transaxle into the vehicle. Fill the Transaxle with Mopar Manual Transaxle Fluid (MS 9417) P/N 4773167. Use of other type fluids
could result in hard shifting, gear or Synchronizer failure.
6.
Install the Transmission Shift Cables to the Transaxle Bracket using the two new Clips (P/N 4269830). Install Tie Strap (P/N 6015756) 7" forward
of the Cable Routing Clip (See Illustration). Pull the Tie Strap tight enough to make the Cable Foam Sleeves contact each other. Clip off the
excess Tie Strap lead.
7.
Perform the Gearshift Cable Crossover Adjustment following the procedure outlined in the Service Manual on Page 21-4.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
21-32-22-91
4.6 Hrs.
FAILURE CODE: P8 - New Part
