Neon L4-2.0L VIN C (1998)
6. Lay the speed control servo, with the speed control cable attached, on top of the engine.
7. Disconnect wiring harness connector from the brake fluid level sensor on master cylinder reservoir.
ICU Mounting Location
8. Disconnect primary and secondary brake tubes from master cylinder. Install plugs at brake tube outlets of master cylinder assembly.
9. Clean the area where the master cylinder attaches to the vacuum booster using a suitable brake cleaner such as Mopar Brake Parts Cleaner or an
equivalent.
CAUTION: On ABS equipped vehicles, vacuum in power booster must be pumped down before removing master cylinder to prevent the booster
from sucking in any contamination. This can be done simply by pumping the brake pedal, with the engine not running, until a firm brake pedal is
achieved.
Master Cylinder Mounting
10. Remove the 2 nuts attaching master cylinder to power brake booster unit.
11. Slide the master cylinder straight out of the vacuum booster unit.
