Neon L4-2.0L VIN C (1998)
Brake Drum: Service and Repair
Brake Drum Removal and Installation
REMOVE
Further clearance can be obtained by backing off the brake automatic adjuster screw. Remove rubber plug from top of brake support plate. Rotate
automatic adjuster screw assembly with an upward motion, using a medium size screwdriver.
1. Raise vehicle on jackstands or centered on a hoist.
2. Remove the rear wheel and tire assemblies from the vehicle.
3. Remove rear brake drum to hub retaining clips (if equipped).
Brake Drum And Hub/Bearing
4. Remove rear brake drum from rear hub/bearing assembly.
5. Inspect brake linings for wear, shoe alignment and contamination.
INSTALL
1. Install rear brake drum assembly on rear hub and bearing assembly.
2. Install the wheel and tire assembly.
3. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
