Neon L4-2.0L VIN C (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removal
1. Disconnect negative (ground) cable from the battery and isolate cable.
PDC Attachment To Thermogaurd
2. Remove the Power Distribution Center (PDC) from the battery thermogaurd. PDC is removed by unlatching the two retaining clips holding it to
the thermogaurd and then pulling it straight up off of the thermogaurd.
Speed Control Servo Bracket Mounting
3. Remove vacuum supply hose from speed control servo.
4. Remove the 2 bolts mounting the bracket for the speed control servo to the body.
Wiring Harness Connection To Speed Control Servo
5. Remove the wiring harness connector from the speed control servo. Then remove the routing clip for the speed control servo wiring harness from
the speed control servo mounting bracket.
