Neon L4-2.0L VIN C (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Installation
1. Install the Integrated Control Unit (ICU) on the mounting bracket.
Hydraulic Control Unit Mounting Bracket
2. Install the 3 bolts attaching the Hydraulic Control Unit (HCU) to the mounting bracket.
3. Tighten the 3 mounting bolts to a torque of 11 Nm (97 inch lbs.).
CAUTION: Before installing the 25 way connector in the CAB be sure that the seal is properly installed in the connector.
Unlocked CAB Connector
4. Install the 25 way connector into the socket on the CAB. The connector is installed using the following procedure. Position the 25 way connector
in the socket on the CAB and carefully push it down as far as it will go. When connector is fully seated into the CAB socket push in the connector
lock as far as it will go. This will pull the 25 connector into the socket on the CAB and lock it in the installed position.
Chassis Brake Tube Connections To HCU
