Neon L4-2.0L VIN C (1998)
2. Remove the 2 screws located in cup holders, attaching front of center console assembly to console bracket.
3. Raise park brake hand lever assembly as high as it will go for required clearance to remove center console.
4. Remove center console assembly from vehicle.
5. Lower park brake lever handle.
Locking Pin Installed In Park Brake Lever
6. Grasp park brake lever output cable by hand and pull upward. Continue pulling on cable until a 3/16 inch drill bit can be inserted into handle and
sector gear of park brake mechanism. This will lock the park brake mechanism and take tension off park brake cables.
RELEASING PARK BRAKE AUTO ADJUSTER
NOTE: The park brake lever can be in any position when releasing the auto adjuster. To ease installation of center console, it is advisable to pull
park brake lever handle all the way up before removing lockout pin
Park Brake Cables Properly Installed In Equalizer
1. Be sure rear park brake cables are properly installed in the equalizer.
2. Pull park brake lever handle all the way up.
