Neon L4-2.0L VIN C (1998)
8. Disconnect vacuum hoses from check valve on power brake vacuum booster. Do not remove check valve from power brake vacuum booster.
NOTE: If vehicle is equipped with antilock brakes, the Hydraulic Control Unit (HCU) needs to be removed from the vehicle to allow removal of
the power brake vacuum booster.
Input Rod Retaining Pin
9. Locate the power brake vacuum booster input rod to brake pedal attachment under instrument panel. Position a small screwdriver under the center
CAUTION: Discard retaining clip when removed, it is not to be reused. Replace only with a new retaining clip when assembled.
10. Rotate screwdriver enough to allow retaining clip tang to pass over the end of the brake pedal pin.
Power Brake Booster Mounting
11. Remove the 4 nuts attaching the power brake vacuum booster to the dash panel. The nuts are accessible from under the instrument panel in the
area of the steering column and brake pedal bracket.
12. Slide power brake vacuum booster forward until mounting studs clear dash panel, then tilt the booster up and to the center of the vehicle to
remove.
