Neon L4-2.0L VIN C (1998)
Valve Guide Seal: Service and Repair
REMOVAL
1. Remove rocker arm shafts assemblies.
2. Rotate crankshaft until piston is at TDC on compression.
3. With air hose attached to adapter tool installed in spark plug hole, apply 90-120 psi air pressure.
Removing And Installing Valve Spring
4. Using Special Tool MD-998772A with adapter 6779 compress valve springs and remove valve locks.
5. Remove valve spring.
Valve Stem Oil Seal Tool
6. Remove valve stem seal by using a valve stem seal tool.
INSTALLATION
Valve Spring Assembly
1. Install valve seal/valve spring seat assembly as outlined in the Valve Installation procedure in this section.
2. Using Special Tool MD-998772A compress valve springs only enough to install locks. Correct alignment of tool is necessary to avoid nicking
