Neon L4-2.0L VIN C (1998)
10. Route power steering pressure hose to pressure port on power steering gear. Install power steering pressure hose, on steering gear and loosely
install tube nut into steering gear. Tighten and torque tube nut after routing bracket is installed, correctly positioning hoses in vehicle.
11. Install the power steering pressure and return hose routing clip on hoses. Install bolt attaching routing clip to front suspension crossmember.
Torque routing clip to front suspension crossmember attaching bolt to 23 Nm (17 ft. lbs.).
12. Torque power steering pressure hose to steering gear tube nut to 34 Nm (25 ft. lbs.).
13. Install power steering pressure hose in routing clip on generator shield.
14. Lower Vehicle.
15. Position locating pin on power steering pressure hose banjo fitting so it is against power steering pump mounting bracket. While holding locating
pin against power steering pump bracket, torque pump end Banjo bolt to 34 Nm (25 ft. lbs.).
16. Securely tighten bolt attaching power steering pressure hose bracket to generator shield.
17. Start the engine and let run for a few seconds. Then turn the engine off.
18. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
19. Raise front wheels of vehicle off the ground.
20. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops. Then turn the engine off.
21. Add power steering fluid if necessary.
