Neon L4-2.0L VIN C (1998)
Crankshaft Damper-Installation
18. Install crankshaft damper using M12-1.75 x 150 mm bolt, washer, thrust bearing and nut from Special Tool 6792. Install crankshaft damper bolt
and tighten to 142 Nm (105 ft. lbs.).
19. Install accessory drive belts.
20. Raise vehicle on hoist and install right inner splash shield.
21. Lower vehicle and perform camshaft and crankshaft timing relearn procedure as follows:
-
Connect DRB scan tool to the data link (diagnostic) connector. This connector is located in the passenger compartment; at the lower edge of
instrument panel; near the steering column.
-
Turn the ignition switch on and access the "miscellaneous" screen.
-
Select "re-learn cam/crank" option and follow directions on DRB screen.
With Mechanical Tensioner
REMOVAL
1. Remove accessory drive belts.
Right Inner Splash Shield
2. Raise vehicle on a hoist and remove right inner splash shield.
