Neon L4-2.0L VIN C (1998)
**6. Replace the upper strut mount by following the procedures in the 1998 Neon Service Manual (Publication No. 81-270-8025),
Removal/Installation, pages 2-16 to 2-17, and Assembly/Disassembly procedures 1 thru 5 on pages 2-30 to 2-31 (Figure 2). The torque for the new
upper strut mount nuts is 61 Nm (45 ft.lbs).**
**7. Remove and replace the right engine mount as outlined in the 1998 Neon Service Manual (Publication No. 81-270-8025) (SOHC - pg
9-18)(DOHC - pg 9-64). After replacing the right engine mount, squirt enough grease (Silicone Spray - p/n 04318070) between the mount snubber
and the engine bracket to fill the gap (Figure 3).**
NOTE:
IF THE SILICONE SPRAY (P/N 04318070) IS NOT AVAILABLE, ANOTHER SILICONE SPRAY MAY BE USED. HOWEVER THE
SUBSTITUTE SILICONE SPRAY MUST NOT BE PETROLEUM BASED.
**8. Inspect and tighten remaining suspension components to specification; repair or replace as needed.**
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
02-05-30-93
Knuckles and Mounts - Replace - All
2.9 Hrs.
02-05-39-91
Upper Strut Mounts and Engine Mount - Replace
1.3 Hrs.
09-40-21-91
Engine Mount Replace
0.3 Hrs.
FAILURE CODE: P8 - New Part