Neon L4-2.0L VIN C (1998)
11. From interior of vehicle, reconnect the steering gear coupler with the steering column shaft coupler. Install steering gear coupler retaining pinch
bolt and torque to 28 Nm (250 inch lbs.). Be sure to install the upper to lower steering couplet retaining bolt, retention pin.
CAUTION: Do not use automatic transmission fluid.
12. Fill power steering pump fluid reservoir to the (Full-Cold) proper level.
13. Start the engine and let run for a few seconds. Then turn the engine off.
14. Add fluid if necessary.
15. Raise front wheels of vehicle off the ground.
16. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level, and inspect
system for leaks. Fill pump reservoir to correct level with Mopar (R), Power Steering Fluid, or equivalent.
17. Lower front wheels of vehicle back on the ground.
CAUTION: During this procedure do not allow the steering gear inner tie rod boots to become twisted.
18. Adjust the front Toe setting on the vehicle. Refer to Alignment.
Outer Tie Rod End Jam Nut
19. Tighten tie rod jam nut to 61 Nm (45 ft. lbs.) torque.
20. Adjust steering gear to tie rod boots at tie rods.
