Neon L4-2.0L VIN C (1998)
Wheel Bearing: Service and Repair
Installation
1. Wipe bore of steering knuckle clean of any grease or dirt with a clean dry shop towel.
2. Clean the rust preventative from the replacement wheel bearing using a clean dry shop towel.
Pressing Wheel Bearing Into Steering Knuckle
3. Place new wheel bearing into bore of steering knuckle. Be sure wheel bearing is placed squarely into the bore. Place steering knuckle in an arbor
press with Receiver, Special Tool C-4698-2 or equivalent supporting the steering knuckle. Place Diver, Special Tool 5052 or equivalent on the
outer race of the wheel bearing. Press the wheel bearing into the steering knuckle until it is fully bottomed in the bore of the steering knuckle.
NOTE: Only the original or original equipment replacement bolts are to be used to mount the bearing retainer to the steering knuckle. If a bolt
requires replacement when installing the bearing retainer plate refer to the Mopar Parts Catalog for the correct replacement bolts.
Wheel Bearing Retainer Plate
4. Install the bearing retainer plate on the steering knuckle. Install the 3 bearing retainer mounting bolts. Tighten the bearing retainer plate mounting
bolts to a torque of 28 Nm (250 inch lbs.).
5. Install removed wheel mounting stud into the
