Neon L4-2.0L VIN C (1998)
Seals and Gaskets: Service and Repair
NOTE: The pump oil seal can be replaced without removing the pump and reaction shaft support assembly from the transaxle case.
Remove Pump Oil Seal
REMOVAL
Screw seal remover Tool C-3981-B into seal, then tighten screw portion of tool to withdraw the seal.
Install Pump Oil Seal
INSTALLATION
To install a new seal, place seal in opening of the pump housing (lip side facing inward). Using Tool C-4193 and Handle Tool C-4171, drive new seal
into housing until tool bottoms.