Neon L4-2.0L VIN C (1998)
6. Cable End Removal:Use a slight twisting motion while grasping the grommet and body to remove the cable from the dash panel and clutch
bracket. a screwdriver may be required to dislodge the cable grommet from the dash panel. Use caution to avoid damage to the cable grommet.
INSTALLATION:
1. Using a slight twisting motion, insert the self adjuster mechanism end of the clutch cable through the dash panel hole and into the bracket
2. Seat the 8mm wide groove on the cable grommet in the dash panel. Make sure the self adjuster is firmly seated against the clutch bracket to ensure
proper adjuster mechanism function.
3. Connect the clutch cable to the up-step/spacer.
4. Connect the up-stop/spacer to the clutch pedal.
5. Adjuster mechanism function check: With slight pressure, pull the clutch release lever end of the cable to draw the cable taut. Push the clutch cable
housing toward the dash panel (With less than 15 lbs. of effort the cable housing should move 30-50mm). This indicates proper adjuster
mechanism function. If the cable does not adjust, determine if the mechanism is properly seated on the bracket.
6. If the adjust mechanism functions properly, guide the cable through the slot in the transaxle housing. Connect cable to release lever, seating the
cupped washer securely on lever tangs.
7. Pull back on clutch cable housing and insert into transaxle housing.
8. Reinstall splash cover and Power Distribution Center. Check clutch pedal position switch operation.
