Neon L4-2.0L VIN C (1998)
Outer C/V Joint Correctly Installed On Interconnecting Shaft
4. Outer C/V joint assembly must be installed on interconnecting shaft until cross of outer C/V joint assembly is seated against circlip on
interconnecting shaft.
5. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
6. Install outer C/V joint sealing boot to interconnecting shaft clamp evenly on sealing boot.
Crimping Tool Installed On Sealing Boot Clamp
Sealing Boot Retaining Clamp Installed
7. Clamp sealing boot onto interconnecting shaft using crimper C-4975-A and the following procedure. Place crimping tool C-4975-A over bridge of
clamp. Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face.
CAUTION: Seal must not be dimpled, stretched, or out-of-shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape
it by hand.
8. Position outer C/V joint sealing boot into its retaining groove on outer C/V joint housing. Install sealing boot to outer C/V joint retaining clamp