Neon R/T L4-2.0L VIN F HO (2001)
Rear Door Window Regulator: Removal and Replacement
WINDOW REGULATOR
REMOVAL
1. Remove door trim panel.
2. Remove door glass from regulator channel.
Fig. 3
3. Loosen screws attaching window regulator channel and crank housing to door panel (Fig. 3).
4. Disengage screw and bolt heads from keyhole slots in door panel.
5. Loosen bolts attaching window regulator to door panel.
6. Disengage regulator from door panel, and crank housing.
7. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
8. Remove window regulator from door through access hole in inner panel.
INSTALLATION
1. Position window regulator and crank housing on door panel through access hole in door panel.
2. Tighten bolts attaching window regulator to door panel.
3. Engage window regulator bolt heads on channel to key hole slots in door panel.
4. Tighten screw attaching window regulator channel and crank housing.
5. Position glass to regulator roller channel.
6. Tighten fasteners attaching door glass to roller channel.
7. Install door trim panel.
