Neon R/T L4-2.0L VIN F HO (2001)
Carpet: Service and Repair
Carpets and Floor Mats
CARPETS AND FLOOR MATS
REMOVAL
For removal of the carpet, the carpet will need to be cut under the instrument panel.
1. Remove front seats.
2. Remove rear seat cushion.
Fig. 4
3. Remove bolts attaching front seat belt lower anchors to floor (Fig. 4).
4. Remove door sill trim covers.
5. Remove cowl trim covers.
6. Remove center floor console.
7. Remove decklid release assist handle.
8. Remove lower fasteners from B-pillar trim panel.
9. Pull carpet from behind trim panel.
10. Fold carpet in half toward rear seat.
11. Remove carpet through rear door opening.
INSTALLATION
The new carpet must be cut for installation. The area is mark on the reverse side of the carpet. The location is in front of the tunnel area.
1. Install carpet through rear door opening.
2. Unfold carpet.
3. Tuck carpet behind trim panel.
4. Install lower fasteners holding B-pillar trim panel.
5. Install decklid release assist handle.
6. Install center floor console.
7. Install cowl trim covers.
8. Install door sill trim covers.
9. Install bolts attaching front seat belt lower anchors to floor. Tighten all seat belts to 40 N.m (30 ft.lbs.) torque.
10. Install rear seat cushion.
11. Install front seats.
