Neon R/T L4-2.0L VIN F HO (2001)
3. Unfold the bushing using your fingers or a wooden dowel until the bushing is fully seated into the caliper housing. The bushing flanges should be
seated evenly on both sides of the bushing hole.
4. Lubricate the inside surfaces of the bushing using Mopar Dielectric Grease or an equivalent.
5. Install the guide pin sleeve into one end of bushing until the seal area of bushing is past the seal groove in the sleeve.
6. Holding the convoluted boot on the opposite end of the bushing, push the steel sleeve through the bushing until the bushing boot is fully seated
into the seal groove on that end of sleeve. Install the other end bushing boot into the groove on that end of the bushing sleeve.