Neon R/T L4-2.0L VIN F HO (2001)
8. Remove the brake wheel cylinder from the brake support plate.
INSTALLATION
NOTE: Before proceeding with this procedure, Refer to Service Precautions.
1. Install a new O-ring at the mating surface of the wheel cylinder-to-brake support plate.
NOTE: When installing wheel cylinder on brake support plate, be sure it is positioned squarely (horizontal) to the brake assembly.
2. Install the wheel cylinder onto brake support plate. Tighten the attaching bolts to a torque of 13 Nm (115 inch lbs.).
3. Hand start the rear brake flex hose tube fitting to wheel cylinder. Tighten the tube nut to a torque of 17 Nm (145 inch lbs.).
4. Install the rear brake shoes on the brake support plate. Replace them as necessary.
5. Install the rear brake drum onto the rear hub.
6. Install the tire and wheel assembly. Tighten the wheel mounting nuts to a torque of 135 Nm (100 ft. lbs.).
7. Adjust the rear brakes.
8. Lower the vehicle.
9. Remove the brake pedal holder.
10. Bleed the wheel cylinder as necessary.
11. Road test the vehicle to make sure the brakes operate correctly.
