Neon R/T L4-2.0L VIN F HO (2001)
Piston: Procedures
CYLINDER BORE AND PISTON - FITTING
Piston and cylinder wall must be clean and dry. Piston diameter should be measured 90 degrees to piston pin about 14 mm (9/16 inch.) from the
bottom of the skirt as shown in (Fig. 80). Cylinder bores should be measured halfway down the cylinder bore and transverse (measurement location B)
to the engine crankshaft center line shown in (Fig. 79). Correct piston to bore clearance must be established in order to assure quiet and economical
operation.
NOTE: Pistons and cylinder bores should be measured at normal room temperature, 70°F (21°C).
