Neon R/T L4-2.0L VIN F HO (2001)
When valves have been removed for inspection, reconditioning or replacement, valve springs should be tested (Fig. 46). As an example; the
compression length of the spring to be tested is 38.00 mm (1.496 inch). Turn table of Tool C-647 until surface is in line with the 38.00 mm (1.496
inches.) mark on the threaded stud and the zero mark on the front. Place spring over stud on the table and lift compressing lever to set tone device.
Pull on torque wrench until ping is heard. Take reading on torque wrench at this instant. Multiply this reading by two. This will give the spring load at
test length. Fractional measurements are indicated on the table for finer adjustments. Refer to Engine Specifications to obtain specified height and
allowable tensions. Replace springs that do not meet specifications.
INSTALLATION
CYLINDER HEAD OFF
1. Coat valve stems with clean engine oil and insert in cylinder head.
2. Install new valve stem seals.
CAUTION: If oversize valves are used, there is only one oversize valve available. The same stem seal is used on both the standard and oversize
valve.
NOTE: On the high output R/T engine, the valve spring MUST be oriented properly when installed. The closely spaced spring coils should be
