Neon R/T L4-2.0L VIN F HO (2001)
Check for torn or missing O-rings at the mating surface of the manifold (Fig. 141).
INSTALLATION
Before installing manifold. Clean all mating surfaces. Replace all O-ring gaskets with new gaskets (Fig. 142). All intake manifold fasteners and
washers are to be discarded and NEW fasteners and washers are to be used.
1. Install intake manifold onto cylinder head and tighten fasteners to 12 Nm (105 in. lbs.) in sequence shown in (Fig. 140).
2. Install intake manifold to lower support bracket bolts (Fig. 139). Tighten bolts to 11 Nm (95 in. lbs.).
3. Remove covering from fuel injector holes and insure the holes are clean. Install fuel rail assembly to intake manifold, Tighten screws to 23 Nm
(200 in. lbs.).
