Neon R/T L4-2.0L VIN F HO (2001)
4. Connect PCV and brake booster hoses.
5. Inspect quick connect fittings for damage, replace if necessary. Apply a light amount of clean engine oil to fuel inlet tube. Connect fuel supply
hose to fuel rail assembly. Check connection by pulling on connector to insure it locked into position.
6. Install the fuel injector cover (Fig. 134).
7. Connect Manifold Absolute Pressure (MAP) Sensor wiring connector (Fig. 137).
8. Connect knock sensor connector, and wiring at starter.
9. Install inlet air duct to intake manifold and throttle body. Tighten clamp to 3 Nm (30 in. lbs.).
10. Connect negative cable to battery.
11. With the DRB scan tool use ASD Fuel System Test to pressurize system to check for leaks.
CAUTION: When using the ASD Fuel System Test, the Auto Shutdown (ASD) relay will remain energized for 7 minutes or until the ignition
switch is turned to the OFF position, or Stop All Test is selected.
